Cutting Vinyl Lattice With Hand Saw

Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line.

Cutting vinyl lattice with hand saw.

If you have a helper a table saw is ideal. In case you have to do a lot of cutting in straight lines with the plastic lattice the circular saw or power saw with the plastic cutting blade is your best option. Start by cutting your vinyl lattice. Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade.

The best way to cut vinyl lattice is to use a circular saw and a cutting blade. Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade. Ease the saw or blade carefully through the lattice. On the other hand if you need to cut the plastic lattice into angles and curves you should use a power saber saw.

Adjust the blade depth on a circular saw by releasing the blade lever on the back. Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood. Set the blade depth 0 5 in 1 3 cm wider than the lattice s thickness. If you plan to make angled or curved cuts use a power saber saw.

This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you. The width depth of the blade may offer a bit more straight. I had to replace a couple vinyl lattice sections that w. Remove the t square guide and the rip fence.

You can also use a trim saw or a handsaw. To cut vinyl lattice attach a vinyl cutting blade to the power saw. Hold the saw against the lattice as if you were about to cut it then let the blade dip roughly 0 5 in 1 3 cm below the level of the lattice. Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line.

If necessary walk on the lattice to the side of the lumber opposite the saw and marked line. If you don t have a vinyl cutting blade you can use another fine toothed blade. Have your helper assist you in guiding. Cut correctly be sure the lattice face side is upward when a fine toothed hard saw is in use.